Link-Plu Table Programming (Submode 25) - TEC MA-1595-1 SERIES Owner's Manual

6. PROGRAMMING OPERATIONS
Deletion
CONDITION
OPERATION
20 [X]
NOTE: When a Salesperson Code is deleted in the above operation, no entries using that code will be
accepted until the code is again opened in the "Programming" operation already described.
Example) To delete Salesperson Code 3 (name: Jansen) that was once programmed:
Key Operation: Mode Lock: SET, Enter 20 and depress the [X] key.
[ITEM CORR]
3 [ST]
[AT/TL]
6.12

Link-PLU Table Programming (Submode 25)

This submode programs Link-PLU Tables and their respective Sub-link PLUs. When a PLU is programmed with a
Link-PLU Table No. (Address 10 of the PLU TABLE PROGRAMMING operation), an entry of the PLU will
automatically enter the Sub-link PLU that is programmed in the Link-PLU Table No. Refer to the "Link-PLU Table
No." description in the PLU TABLE PROGRAMMING, Submode 4, as to details of PLU-to-PLU Iinkage.
CONDITION
OPERATION
25 [X]
(Enter the Table No. programmed in the
Head-link PLU item in Submode 4)
After Daily Salesperson Reset
Mode Lock: SET
[ITEM CORR]
or
[VOID]
Repeat for other salesperson to be deleted.
Any time outside a sale
Mode Lock: SET
| Link-PLU Table No. | [ST]
1 to 99
Repeat for other tables.
6.12 Link-PLU Table Programming (Submode 25)
| Salesperson Code | [ST]
Max. 2 digits (1 to 99)
Barcode Scanning
| Sub-link PLU Code | [PLU]
6 or 13 digits
(Enter the code of the PLU to be auto-
entered when the Head-link PLU is
entered in a sale.)
* (For sequentially programming tables, the
Table No. specification can be skipped.)
6-29
[AT/TL]
7(& 6725(
7(& 6725(
 3($&+ '5,9(
3+21( 
2SHQ  DP WR  SP
&ORVHG HYHU\ :HGQHVGD\
 021 
3 3
 -DQVHQ

  70
[AT/TL]
EO1-11152