Verification Of Programmed Data - TEC MA-600-1 series Owner's Manual

5. VERIFICATION OF PROGRAMMED DATA

5. VERIFICATION OF PROGRAMMED DATA
The programmed data entered in the preceding chapter can be read for verification purposes.
The print format of each program reading is almost the same as on the program receipt, except that "X" is printed
instead of printing Program Name.
CONDITION Any time outside a sale
OPERATION
Mode Lock: X or SET
1. Turn the Mode Lock to the X or SET position with the MGR key.
2. In X mode, move the cursor on to 3 PROGRAM DATA READ which is displayed on the LCD display with the
[↓] key, then depress the [Enter] key. In SET mode, move the cursor on to 7 PROGRAM DATA READ, then
depress the [Enter] key.
3. PROGRAM DATA READ menu is shown on the next page. Move the cursor on to a desired item to be
verified with the [↓] key, then depress the [Enter] key.
4. The currently programmed data is printed both on the receipt and on the journal.
NOTE: On depressing the [Enter] key, the programmed data will be printed. To abort printing once started,
depress the [ITEM CORR] key. The reading operation is immediately stopped halfway.
Example)
To verify the preset rates of the [%-] and [%+] keys in X mode.
1. When the ECR is being outside a sale and in X mode, depress
the [↓] key twice to move the cursor on 3 PROGRAM DATA
READ.
2. Depress the [3] or [Enter] key.
3. Depress the [↓] key three times to move the cursor on 4 RATE,
LIMIT AMOUNT.
4. Depress the [4] or [Enter] key.
5. The [1] or [Enter] key depression results in printing.
5- 1
5. VERIFICATION OF PROGRAMMED DATA
10-20-2006 FRI
X RATE
%- 5%
%+ 3%
EO1-11155
#0
0090 16:54TM