Programming Operations; Programming Operations Common With Standalone Ecr Level - TEC MA-1595-1 SERIES Owner's Manual

5. PROGRAMMING OPERATIONS

5. PROGRAMMING OPERATIONS
The system should be programmed fully by your local TOSHIBA TEC representative at the time of delivery
according to the user's requirements so that daily operations can immediately start. However, some data must be
added or changed daily or in a longer period. Since the volume of programming contents for the system is too
large, this chapter and the following two chapters are provided as guide lines of the user's daily programming and
maintenance operations. If there are any unclear points or program data other than listed here must be changed
or added, please contact your TOSHIBA TEC representative. Please also note that some programming
operations introduced in the Standalone Level are modified or not available on in-line terminals.

5.1 Programming Operations Common with Standalone ECR Level

The following is the table of programming operations which are introduced in the Manager's Guide for the
Standalone Level and can be operated on in-line terminals as well, with the Submode No. and operation
sequence unchanged. However, on in-line terminals, these are usually operated on the Master Terminal only
and down-line-loaded (DLLed) to all the Satellite Terminals. Therefore, if any program data is changed, a DLL is
further necessary to load the new data (after the change) to all the Satellite Terminals (to be described in Chapter
6).
*1
Master : Programming job to be available when the [RTR] key is activated on the Master Terminal
*2
Satellite : Programming job to be available on the Backup Master Terminal and the Satellite Terminal when the
[RTR] key is off on the Master Terminal
Submode
No.
1 Store Name/Message and Commercial Message Programming
2 Cashier Code and Name Programming
4 PLU Table Programming
5 Time Setting or Adjustment
6 Date Setting or Adjustment
8 Amount Limit Setting for Function Keys
15 Customer File Code (Check Track No.) and Name Programming
20 Salesperson Code and Name Programming
25 Link PLU Table Programming
26 Tare Table and General Unit Weight Setting
27 PLU Preset-code Key Setting
31 Display Message Programming
35 Negative Amount Key Limit Amount Setting
40 PLU Price Dollar Discount/Extra Charge Amount Setting
No Department Preset Price Setting or Changing
Submode
PLU Preset Price Setting or Changing,
Whole Package Quantity Changing
%+ and %- Preset Rate Setting
Preset Rate Setting for Selective Itemizers
Foreign Currency Exchange Rate Setting
Tax Table Programming
Store/Register No. Setting
5.1 Programming Operations Common with Standalone ECR Level
PROGRAMMING JOB LIST
Programming Job
5- 1
EO1-11152
O: Available
Terminals
*1 *2
Master Satellite
O O
O
O
O O
O O
O O
O
O
O
O
O O
O O
O
O
O
O
O O
O O
O
O
O O