Terminal Designation - TEC MA-1595-1 SERIES Owner's Manual

2. OPERATIONS BEFORE IN-LINE SERVICE

2.2 Terminal Designation

This operation can be performed before any in-line service operation. When this operation is skipped, no specific
terminals are designated, i.e., the in-line service operations will be performed to all the terminals.
Any time outside a sale
CONDITION
OPERATION Mode Lock: SET, X, or Z (depending on the in-line service operations to follow)
[#] |Store/Register No.| [#]
Enter the Store/Register No.
(Max. 6 digits) of the Terminal
subject to the in-line service
operations to follow.
Repeat for other terminals if more are
subject to the in-line service operation.
NOTE: The Terminal Designation once declared by the above operation will be canceled by changing the
position of the Mode Lock, or by RTR Declaration Cancel, or by turning OFF and ON the power of the
terminal. The designation is automatically canceled on completion of the operation to follow or when
a new designation is operated.
ex.) To designate the following Terminal out of two terminals in the system:
Terminal ID No.3: Store/Register No. 333303 (IP Address: 192.168.0.251)
Mode Lock: SET (if operated before DLLs)
The RTR Declaration must be ON (i.e., the IN-LINE Lamp must be illuminated; if not, depress the [RTR] key
to declare RTR status).
[#] 333303 [#] [AT/TL]
(Issues a receipt, printing the Store/Register Nos. of the terminals designated in the above operation.)
RTR Declaration ON Status (i.e., the IN-LINE Lamp should be illuminated)
To be operated on the Master Terminal only.
2SHQ  DP WR  SP
&ORVHG HYHU\ :HGQHVGD\
 681 

[AT/TL]
7(& 6725( 7(& 6725(
 3($&+ '5,9(
3+21( 
3 3
   
  70
2- 2
EO1-11152
2.2 Terminal Designation