Programmed Data Verification - TEC MA-1535-2 series Owner's Manual

5. PROGRAMMED DATA VERIFICATION

5. PROGRAMMED DATA VERIFICATION
Whenever programming operations are performed, it is recommended to issue Program Verification
receipts to check the programmed data before entering any other operation. The print format of each
program reading is almost the same as that of the program receipt.
CONDITION
OPERATION
1) Programmed data read for each Submode
X mode
90 [AT/TL]
SET mode
90 [#/NS]
NOTES: 1. Printing will be cancelled by depressing the [C] key during report print.
2. The pass code assigned to individual cashier is printed not in X mode but in SET mode.
2) Zone PLU Read
X mode
90 [AT/TL]
SET mode
90 [#/NS]
NOTES: 1. Printing will be cancelled by depressing the [C] key during report print.
2. The Zone-end PLU Code must be bigger than the Zone-start PLU Code. Failure to do this may
cause an error.
When the report is issued
in X mode:
When the report is issued
in SET mode:
Zone-start PLU Code
Zone-end PLU Code
Anytime outside a sale
Control Lock: X or SET
01 [#/NS]
01 [#/NS]
02 [#/NS] |Zone-start PLU Code| [X/TIME]
14 digits
02 [#/NS] |Zone-start PLU Code| [X/TIME]
14 digits
X
P R G
|Submode No.| [AT/TL]
2 digits (01 to 59)
|Submode No.| [AT/TL]
2 digits (01 to 59)
; ;  
5- 1
5. PROGRAMMED DATA VERIFICATION
[#/NS]
[#/NS]
|Zone-end PLU Code| [AT/TL] [#/NS]
14 digits
|Zone-end PLU Code| [AT/TL] [#/NS]
14 digits
EO1-11149