Static Route Edit - ZyXEL Communications P-2612HW Series User Manual

16.2.1 Static Route Edit

Select a static route index number and click Edit. The screen shown next appears.
Use this screen to configure the required information for a static route.
Figure 189 Advanced > Static Route > Edit
The following table describes the labels in this screen.
Table 108 Advanced > Static Route > Edit
LABEL
Active
Route Name
Destination IP
Address
IP Subnet
Mask
Gateway IP
Address
Back
Apply
Cancel
P-2612HW Series User's Guide
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter the name of the IP static route. Leave this field blank to delete this
static route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is a router or switch on
the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Click Back to return to the previous screen without saving.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
Chapter 16 Static Route
323