Configuring More Connections Advanced Setup - ZyXEL Communications P-2612HW Series User Manual

Chapter 6 WAN Setup

6.3.2 Configuring More Connections Advanced Setup

To edit your ZyXEL Device's advanced WAN settings, click the Advanced Setup
button in the More Connections Edit screen. The screen appears as shown.
Figure 78 Network > WAN > More Connections: Edit: Advanced Setup
The following table describes the labels in this screen.
Table 23 Network > WAN > More Connections: Edit: Advanced Setup
LABEL
RIP & Multicast Setup
RIP Direction
RIP Version
Multicast
ATM QoS
ATM QoS Type
110
DESCRIPTION
This section is not available when you configure the ZyXEL Device
to be in bridge mode.
Select the RIP direction from None, Both, In Only and Out
Only.
Select the RIP version from RIP-1, RIP-2B and RIP-2M.
IGMP (Internet Group Multicast Protocol) is a network-layer
protocol used to establish membership in a multicast group. The
ZyXEL Device supports both IGMP version 1 (IGMP-v1) and
IGMP-v2. Select None to disable it.
Select CBR (Continuous Bit Rate) to specify fixed (always-on)
bandwidth for voice or data traffic.
Select UBR (Unspecified Bit Rate) for applications that are non-
time sensitive, such as e-mail.
Select VBR-RT (real-time Variable Bit Rate) type for applications
with bursty connections that require closely controlled delay and
delay variation.
Select VBR-nRT (non real-time Variable Bit Rate) type for
connections that do not require closely controlled delay and delay
variation.
P-2612HW Series User's Guide