Id Type And Content Examples - ZyXEL Communications P-2612HW Series User Manual

With main mode
encrypted to provide identity protection. In this case the ZyXEL Device can only
distinguish between up to 12 different incoming SAs that connect from remote
IPSec routers that have dynamic WAN IP addresses. The ZyXEL Device can
distinguish up to 12 incoming SAs because you can select between three
encryption algorithms (DES, 3DES and AES), two authentication algorithms (MD5
and SHA1) and two key groups (DH1 and DH2) when you configure a VPN rule
(seeSection 14.4 on page
identification for incoming SAs.
The type of ID can be a domain name, an IP address or an e-mail address. The
content is the IP address, domain name, or e-mail address.
Table 89 Local ID Type and Content Fields
LOCAL ID
TYPE=
IP
DNS
E-mail
Table 90 Peer ID Type and Content Fields
PEER ID
TYPE=
IP
DNS
E-mail

14.9.9.1 ID Type and Content Examples

Two IPSec routers must have matching ID type and content configuration in order
to set up a VPN tunnel.
P-2612HW Series User's Guide
(seeSection 14.9.6 on page
268). The ID type and content act as an extra level of
CONTENT=
Type the IP address of your computer or leave the field blank to have
the ZyXEL Device automatically use its own IP address.
Type a domain name (up to 31 characters) by which to identify this
ZyXEL Device.
Type an e-mail address (up to 31 characters) by which to identify this
ZyXEL Device.
The domain name or e-mail address that you use in the Content field is
used for identification purposes only and does not need to be a real
domain name or e-mail address.
CONTENT=
Type the IP address of the computer with which you will make the VPN
connection or leave the field blank to have the ZyXEL Device
automatically use the address in the Secure Gateway Address field.
Type a domain name (up to 31 characters) by which to identify the
remote IPSec router.
Type an e-mail address (up to 31 characters) by which to identify the
remote IPSec router.
The domain name or e-mail address that you use in the Content field is
used for identification purposes only and does not need to be a real
domain name or e-mail address. The domain name also does not have to
match the remote router's IP address or what you configure in the
Secure Gateway Address field below.
283), the ID type and content are
Chapter 14 VPN
285