ZyXEL Communications P-2612HW Series User Manual page 165

8.9.5.4 Example WPS Network Setup
This section shows how security settings are distributed in an example WPS setup.
The following figure shows an example network. In step 1, both AP1 and Client 1
are unconfigured. When WPS is activated on both, they perform the handshake. In
this example, AP1 is the registrar, and Client 1 is the enrollee. The registrar
randomly generates the security information to set up the network, since it is
unconfigured and has no existing information.
Figure 107 WPS: Example Network Step 1
ENROLLEE
CLIENT 1
In step 2, you add another wireless client to the network. You know that Client 1
supports registrar mode, but it is better to use AP1 for the WPS handshake with
the new client since you must connect to the access point anyway in order to use
the network. In this case, AP1 must be the registrar, since it is configured (it
already has security information for the network). AP1 supplies the existing
security information to Client 2.
Figure 108 WPS: Example Network Step 2
CLIENT 1
ENROLLEE
CLIENT 2
In step 3, you add another access point (AP2) to your network. AP2 is out of
range of AP1, so you cannot use AP1 for the WPS handshake with the new access
P-2612HW Series User's Guide
SECURITY INFO
EXISTING CONNECTION
Chapter 8 Wireless LAN
REGISTRAR
AP1
REGISTRAR
AP1
165