ZyXEL Communications P-2612HW Series User Manual page 348

Chapter 18 Quality of Service (QoS)
Table 114 Advanced > QoS > Class Setup > Add (continued)
LABEL
MAC Mask
Exclude
Others
Service
Protocol
Packet Length
DSCP
Ethernet Priority
VLAN ID
Physical Port
Exclude
TCP ACK
Back
Apply
Cancel
348
DESCRIPTION
Type the mask for the specified MAC address to determine which bits
a packet's MAC address should match.
Enter "f" for each bit of the specified destination MAC address that the
traffic's MAC address should match. Enter "0" for the bit(s) of the
matched traffic's MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a
MAC address of 00:13:49:12:34:56 matches this criteria.
Select this option to exclude the packets that match the specified
criteria from this classifier.
This field simplifies classifier configuration by allowing you to select a
predefined application. When you select a predefined application, you
do not configure the rest of the filter fields.
SIP (Session Initiation Protocol) is a signaling protocol used in
Internet telephony, instant messaging and other VoIP (Voice over IP)
applications. Select the check box and select VoIP(SIP) from the
drop-down list box to configure this classifier for traffic that uses SIP.
File Transfer Protocol (FTP) is an Internet file transfer service that
operates on the Internet and over TCP/IP networks. A system running
the FTP server accepts commands from a system running an FTP
client. The service allows users to send commands to the server for
uploading and downloading files. Select the check box and select FTP
from the drop-down list box to configure this classifier for FTP traffic.
Select this option and select the protocol (TCP or UDP) or select User
defined and enter the protocol (service type) number. 0 means any
protocol number.
Select this option and enter the minimum and maximum packet
length (from 28 to 1500) in the fields provided.
Select this option and specify a DSCP (DiffServ Code Point) number
between 0 and 63 in the field provided.
Select this option and select a priority level (between 0 and 7) from
the drop down list box.
"0" is the lowest priority level and "7" is the highest.
Select this option and specify a VLAN ID number between 2 and 4094.
Select this option and select a LAN port.
Select this option to exclude the packets that match the specified
criteria from this classifier.
Select this option to set this classifier for TCP ACK (acknowledgement)
packets.
Click Back to go to the previous screen.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
P-2612HW Series User's Guide