The Class Setup Screen - ZyXEL Communications P-2612HW Series User Manual

Table 112 Advanced > QoS > General
LABEL
Apply
Cancel

18.3 The Class Setup Screen

Use this screen to add, edit or delete classifiers. A classifier groups traffic into data
flows according to specific criteria such as the source address, destination
address, source port number, destination port number or incoming interface. For
example, you can configure a classifier to select traffic from the same protocol
port (such as Telnet) to form a flow.
Click Advanced > QoS > Class Setup to open the following screen.
Figure 205 Advanced > QoS > Class Setup
The following table describes the labels in this screen.
Table 113 Advanced > QoS > Class Setup
LABEL
Create a new
Class
Order
Active
Name
Interface
P-2612HW Series User's Guide
DESCRIPTION
Click Apply to save your settings back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Click Add to create a new classifier.
This is the number of each classifier. The ordering of the classifiers is
important as the classifiers are applied in turn.
Select the check box to enable this classifier.
This is the name of the classifier.
This shows the interface from which traffic of this classifier should
come.
Chapter 18 Quality of Service (QoS)
343