Ftp Command Configuration Backup Example; Configuration Backup Using Gui-Based Ftp Clients; Backup Configuration Using Tftp - ZyXEL Communications P-2612HW Series User Manual

25.5.2 FTP Command Configuration Backup Example

This figure gives an example of using FTP commands from the DOS command
prompt to save your device's configuration onto your computer.
Figure 254 FTP Session Example
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit

25.5.3 Configuration Backup Using GUI-based FTP Clients

The following table describes some of the commands that you may see in GUI-
based FTP clients.
Table 160 General Commands for GUI-based FTP Clients
COMMAND
Host Address
Login Type
Transfer Type
Initial Remote
Directory
Initial Local Directory

25.5.4 Backup Configuration Using TFTP

The ZyXEL Device supports the up/downloading of the firmware and the
configuration file using TFTP (Trivial File Transfer Protocol) over LAN. Although
TFTP should work over WAN as well, it is not recommended.
P-2612HW Series User's Guide
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied
to the server for anonymous access. Anonymous logins will work
only if your ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary
mode.
Specify the default remote directory (path).
Specify the default local directory (path).
Chapter 25 Tools
427