Transport - Genie S-60 Operator's Manual

Second Edition • Fifth Printing
Observe and Obey:
Transport vehicle must be parked on a level
surface.
Transport vehicle must be secured to prevent
rolling while machine is being loaded.
Be sure vehicle capacity, loading surfaces and
straps or lines are sufficient to withstand
machine weight. See Specifications section.
Securing to Truck or Trailer for
Transit
Always use the turntable rotation lock pin each time
the machine is transported.
Always chock machine wheels in preparation for

transport.

Use tie points on drive chassis for anchoring down
to transport surface.
Part No. 43648
Transport Instructions
Disengage
Position
Engage
Position
Genie S-60 & Genie S-65
Use the lower platform mount between the boom
end and the platform to secure the boom from side-
to-side movement. Do not use excessive
downward force when securing the boom section.
Use chains or straps of ample load capacity.
Turn the key switch to the
the key before transporting.
Inspect the entire machine for loose or unsecured
items.
Free-wheel Configuration for
Winching
Chock the wheels to prevent the machine from
rolling.
2WD models: Release non-steer wheel brakes by
turning over the torque hub disconnect caps (see
below).
4WD models: Release wheel brakes by turning
over all four torque hub disconnect caps (see
below).
Be sure the winch line is properly secured to the
drive chassis tie points and the path is clear of all
obstructions.
Reverse procedures described to re-engage
brakes.
Note: The pump free-wheel valve should always
remain closed.
Operator's Manual
position and remove
OFF
25