Genie S-60 Operator's Manual page 26

Operator's Manual
OPERATING INSTRUCTIONS
To Drive
1 Move the lift/drive select switch to the drive
position (if equipped).
2 Press down the foot switch.
3 Increase speed: Slowly move the drive control
handle off center.
Decrease speed: Slowly move the drive control
handle toward center.
Stop: Return the drive control handle to center
or release the foot switch.
Use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Machine travel speed is restricted when the boom
is raised or extended.
Drive Enable
Light indicates that the boom has moved just
ON
past either non-steering wheel and drive function
has been interrupted.
To drive, hold the drive enable switch to either
side and slowly move the drive control handle off
center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on
the platform controls and the drive chassis to
identify the direction the machine will travel.
Generator
To operate the generator, move the generator
toggle switch to the generator position. The engine
will continue to run but no drive or platform
functions will operate.
Plug power tool into the power to platform GFCI
outlet.
To resume machine functions, move the generator
toggle switch to machine functions position. All
functions will operate.
24
Engine Idle Select (rpm)
Select engine idle (rpm) using the symbols on the
control panel.
· Rabbit and foot switch symbol:
foot switch activated high idle
· Turtle symbol: low idle
· Rabbit symbol: high idle
Check Engine Light (if equipped)
Light on and engine stopped: Tag the machine
and remove from service.
Light on and engine still running: Contact service
personnel within 24 hours.
Stopping the Engine
Push in the red Emergency Stop button and turn
the key switch to the
After Each Use
1 Select a safe parking location—firm level
surface, clear of obstruction and traffic.
2 Retract and lower the boom to the stowed
position.
3 Rotate the turntable so that the boom is
between the non-steering wheels.
4 Turn the key switch to the
remove the key to secure from unauthorized
use.
5 Chock the wheels.
Genie S-60 & Genie S-65
Second Edition • Fifth Printing
position.
OFF
position and
OFF
Part No. 43648