Genie S-60 Operator's Manual page 21

Hide thumbs Also See for S-60:
Table of Contents

Advertisement

Second Edition • Fifth Printing
Test the Oscillating Axle
(if equipped)
37 Move the lift/drive select switch to the drive
position (if equipped).
38 Start the engine from the platform controls.
39 Drive the right steer tire up onto a 6 inch (15.2
cm) block or curb.
Result: The three remaining tires should stay in
firm contact with the ground.
40 Drive the left steer tire up onto a 6 inch (15.2
cm) block or curb.
Result: The three remaining tires should stay in
firm contact with the ground.
41 Drive both steer tires up onto a 6 inch (15.2 cm)
block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
Test the Drive Enable System
42 Move the lift/drive select switch to the lift
position (if equipped).
43 Press down the foot switch and lower the boom
to the stowed position.
44 Rotate the turntable until the boom moves past
one of the non-steering wheels.
Result: The drive enable
indicator light should
come on and remain on
while the boom is
anywhere in the range
shown.
Part No. 43648
45 Move the lift/drive select switch to the drive
position (if equipped).
46 Move the drive control handle off center.
Result: The drive function should not operate.
47 Move and hold the drive enable toggle switch to
either side and slowly move the drive control
handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that the
drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform
controls and the drive
chassis to identify the
direction of travel.
Test Limited Drive Speed
48 Move the lift/drive select switch to the lift
position (if equipped).
49 Press down the foot switch.
50 Raise the boom to just above horizontal.
51 Move the lift/drive select switch to the drive
position (if equipped).
52 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the boom raised should not exceed 1 foot
per second (0.3 meters per second).
Genie S-60 & Genie S-65
Operator's Manual
FUNCTION TESTS
Blue
Yellow
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S-65

Table of Contents