Genie S-60 Operator's Manual page 22

Operator's Manual
FUNCTION TESTS
53 Move the lift/drive select switch to the lift
position (if equipped).
54 Lower the boom to the stowed position.
55 Extend the boom 1 foot (30 cm).
56 Move the lift/drive select switch to the drive
position (if equipped).
57 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the boom extended should not exceed 1
foot per second (0.3 meters per second).
If the drive speed with the boom raised or extended
exceeds 1 foot per second (0.3 meters per second),
immediately tag and remove the machine from
service.
Test Auxiliary Controls
58 Shut off the engine.
59 Pull out the red Emergency Stop button to
the position.
ON
60 Press down the foot switch.
61 Move the lift/drive select switch to the lift
position (if equipped).
62 Simultaneously hold the auxiliary power switch
on and activate each function control handle or
toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate. Drive functions should not operate with
auxiliary power.
20
Test the Lift/Drive Select Switch (if
equipped)
63 Move the lift/drive select switch to the lift
position.
64 Press down the foot switch.
65 Move the drive control handle off center.
Result: No drive functions should operate.
66 Activate each boom function toggle switch.
Result: All boom functions should operate.
67 Move the lift/drive select switch to the drive
position.
68 Press down the foot switch.
69 Activate each boom function toggle switch.
Result: No boom functions should operate.
70 Move the drive control handle off center.
Result: The drive functions should operate.
71 Repair any malfunctions before operating the
machine.
Genie S-60 & Genie S-65
Second Edition • Fifth Printing
Part No. 43648