Genie S-60 Operator's Manual page 25

Second Edition • Fifth Printing
Auxiliary Controls
Use auxiliary power if the primary power source
(engine) fails.
1 Turn the key switch to ground or platform
control.
2 Pull out the red Emergency Stop button to the
position.
ON
3 Move the lift/drive select switch to the lift
position (if equipped) when operating the
auxiliary controls from the platform.
4 Press down the foot switch when operating the
auxiliary controls from the platform.
5 Simultaneously hold the auxiliary power switch
and activate desired function.
ON
The drive function will not operate with auxiliary
power.
Operation from Ground
1 Turn the key switch to ground control.
2 Pull out the red Emergency Stop button to
the position.
ON
3 Gasoline/LPG models: Choose fuel by moving
fuel select switch to desired position.
4 Start the engine.
To Position Platform
1 Hold the function enable switch to either side.
2 Move the appropriate toggle switch according
to the markings on the control panel.
Drive and steer functions are not available from the
ground controls.
Machines equipped with Platform Level Control
Disable Function: The platform level toggle switch
will not operate when the boom is raised or
extended past the drive speed limit switches.
Part No. 43648
Operation from Platform
1 Turn the key switch to platform control.
2 Pull out both ground and platform red
Emergency Stop buttons to the
3 Gasoline/LPG models: Choose fuel by moving
the fuel select switch to the desired position.
4 Start the engine. Do not press down the foot
switch when starting the engine.
To Position Platform
1 Move the lift/drive select switch to the lift
position (if equipped).
2 Press down the foot switch.
3 Slowly move the appropriate function control
handle or toggle switch according to the
markings on the control panel.
Machines equipped with Platform Level Control
Disable Function: The platform level toggle switch
will not operate when the boom is raised or
extended past the drive speed limit switches.
To Steer
1 Move the lift/drive select switch to the drive
position (if equipped).
2 Press down the foot switch.
3 Turn the steering wheels with the thumb rocker
switch located on top of the drive control
handle.
Use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the wheels will turn.
Genie S-60 & Genie S-65
Operator's Manual
OPERATING INSTRUCTIONS
position.
ON
23