Battery Initial Charging - HYOSUNG GD250 Owner's Manual

1. BATTERY INITIAL CHARGING

Initial charging of the battery is required after filling electrolyte to improve the battery
durability.
2. BATTERY INSTALLATION
① Fill the electrolyte to the battery.
② Leave the battery for 30 minutes.
③ C harge the battery by standard charging. This is necessary for reliability of the
battery.
④ Install the battery to the motorcycle.
STANDARD CHARGING TIME
※
Do not use the battery without the battery initial charging.
Otherwise the battery service life may be shortened.
The 『 』 uses a battery ignition system.
Do not permit to start or operate the motorcycle without the battery otherwise the
electrical system will be damage.
Always start or ride the motorcycle with the correct battery installed and connected.
Use only the genuine Hyosung battery on the 『
If use a non genuine battery, as poor performance for low temperature of the battery,
the engine could not start because the ECU is not running by lower battery moment
voltage than 7V when pushing the starter switch.
BATTERY INITIAL CHARGING
: 1.0 A for 10 hours
CAUTION
WARNING
CAUTION
』.
2