Adjusting The Height/Replacing; Angle Adjustable High Mount Footrest; Adjusting The Angle - TiLite TRA AERO T Owner's Manual

CHAPTER 3: FOOTRESTS

Adjusting the Height/Replacing

The Angle Adjustable Footrest can be replaced or the height adjusted by using the tools and following the procedures
under "Titanium Footrest with Flat ABS Cover - Adjusting the Height/Replacing" on page 3-2.

Angle Adjustable High Mount Footrest

Adjusting the Angle

Tools needed:
• 5/32" Allen Wrench (no high mount extension tubes)
• 3/16" Allen Wrench (high mount extension tubes only)
1. Loosen, but do not remove, the two Allen screws that secure the footplate to the clamp. See Figure 3-8. If your
footrest has extension tubes (see Figure 3-9), you will have 3/16" Allen screws in place of locknuts and you will
only need to loosen these latter Allen screws to adjust the angle.
2. Adjust the footrest to the desired angle.
3. Tighten the Allen screws and locknuts (or 3/16" Allen screws), making sure the screws and the locknuts (or 3/16"
Allen screws) are secure and will not permit the footplate to rotate up or down under weight.
Aero T/TRA Owner's Manual
Figure 3-6
Adjusting the Angle
Allen
Screws
Footplate
Figure 3-7
Angle Adjustable Footrest
Allen
Screws
Footrest
Clamps
Washers
Clamp
Locknuts
Frame
Footrest
3-4 OM_Aero T_TRA_0414RevB