Slipstream Single-Sided Forks; Replacing Casters; Replacing Forks; Adjusting The Front Seat Height - Standard Forks - TiLite TRA AERO T Owner's Manual

CHAPTER 11: CASTERS AND FORKS

Slipstream Single-Sided Forks

Replacing Casters

Tools Needed:
• 1/8" Allen Wrench
1. Remove the Allen screw and caster cap. See Figures 11-2.
2. Remove the caster.
3. Install the new caster onto the Slipstream Single-Sided Fork, replace the single sided caster cap and securely
tighten the screw so there is no space between the caster and the Slipstream Single-Sided Fork side.
Note: If you are replacing your casters with a wider caster, you must replace the axle with a longer axle.
Likewise, if you are replacing your wide caster with a smaller width caster, make sure you also order the shorter axle.

Replacing Forks

Tools Needed:
• 9/16" Wrench
• 1/8" Allen Wrench
1. Remove the casters. See "Slipstream Single-Sided Forks – Replacing Casters" on page 11-2.
2. Remove the nylock nut and washer. See Figure 11-2.
3. Remove the old fork and install the replacement fork on the fork stem.
4. Replace the nylock nut and washer and securely tighten.
5. Reinstall the casters. See "Slipstream Single-Sided Forks – Replacing Casters" on page 11-2.
Adjusting the Front Seat Height – Standard Forks
You can adjust the front seat height of your chair up or down without changing the casters to a larger or smaller
size. Follow the procedures under "Standard Forks – Replacing Casters" on page 11-1 to mount the casters in the
alternative axle holes in the fork. The full range of adjustability will not be available with 5" or 6" casters. Additional
adjustability may be achieved with different forks or casters or with fork stem extensions. Contact TiLite Customer
Service for assistance.
Aero T/TRA Owner's Manual
Figure 11-2
Slipstream Single-Sided Fork
Caster Cap
Fork Stem
Fork
11-2
Washer
Nylock Nut
Caster
Caster Cap
Allen
Screw
OM_Aero T_TRA_0414RevB