TiLite TRA AERO T Owner's Manual page 79

Figure 10-8
Standard Handle Positions 1, 2 and 3 (Locked)
Pull to Unlock
Figure 10-10
Reverse Handle Positions 1, 2 and 3 (Locked)
Pull to Unlock
Standard Handle Positions 1, 2, 3
The Uni-Lock ships with the handle in Standard Position 3. If you desire to switch to Standard Positions 1 or 2, follow
the procedures below.
Tools Needed:
• 1/8" Allen Wrench
• 3/8" Open End Wrench
1. As shown in Figure 10-12, the wheel lock handle attaches to the wheel lock handle base with two Allen screws.
There is only one hole in the wheel lock handle base through which to attach the upper Allen screw. There are
three holes in the wheel lock handle base through which to attach the lower Allen screw.
2. Remove the lower Allen screw and locknut that secure the wheel lock handle to the wheel lock handle base.
3. Loosen, but do not remove, the upper Allen screw that secures the wheel lock handle to the wheel lock handle
base.
4. Reposition the wheel lock handle to the desired Standard Handle Position 1, 2 or 3 (see Figures 10-8 and 10-9)
and replace the Allen screw and locknut.
5. Securely tighten both Allen screws and locknuts.
Aero T/TRA Owner's Manual
1
2
3
1
2
3
Figure 10-12
Removing the Wheel Lock Handle
Allen
Screws
10-5
CHAPTER 10: WHEEL LOCKS
Figure 10-9
Standard Handle Positions 1, 2 and 3 (Unlocked)
2
1
Figure 10-11
Reverse Handle Positions 1, 2 and 3 (Unlocked)
2
1
Handle
Locknuts
Base
3
Push to Lock
3
Push to Lock
OM_Aero T_TRA_0414RevB