Angle Adjustable High Mount Footrest
Adjusting the Height/Replacing
The Angle Adjustable High Mount Footrest can be replaced or the height adjusted by using the tools and following the
procedures under "Titanium Footrest with Flat ABS Cover - Adjusting the Height/Replacing" on page 3-2.
Flip-Back Footrest
The Flip-Back Footrest can be flipped upward and backward to position the footplate out of the way for purposes of
transferring into and out of the wheelchair. See Figure 3-10.
Adjusting the Angle
Tools needed:
•
3/16" Allen Wrench
1. Loosen, but do not remove, the two Allen screws that secure the stop clamps to the footrest extension tube. See
Figure 3-11.
2. Adjust the footrest to the desired angle.
3. Tighten the Allen screws. Make sure the screws are secure and will not permit the footplate to rotate up or down
under weight.
Adjusting the Height/Replacing
You can adjust the height of, or replace, the flip back footrest by using the tools and following the procedures for
adjusting the height of, or replacing a footrest as set forth under "Titanium Footrest with Flat ABS Cover - Adjusting
the Height/Replacing" on page 3-2.
Aero T/TRA Owner's Manual
Figure 3-8
Allen
Screws
Locknuts
CHAPTER 3: FOOTRESTS
Angle Adjustable High Mount Footrest
Figure 3-10
Figure 3-10
Flip Back Footrest
Flip Back Footrest
3-5
Figure 3-9
with Extension Tubes
Allen
Screws
Extension Tubes
Allen Screws
OM_Aero T_TRA_0414RevB