Adjusting - TiLite TRA AERO T Owner's Manual

Rear Cam
Conical Washer
Allen Screw #1

Adjusting

Tools Needed:
• 5/32" Allen Wrench
1. Using the 5/32" Allen wrench, loosen but do not remove Allen screw #1. See Figure 6-6.
2. Loosen, but do not remove Allen screw #2 using the 5/32" Allen wrench.
3. Adjust the side guard to the desired position.
4. Securely tighten the two Allen screws.
Note: If you are unable to achieve the desired position, follow the instructions given under "Mounting" on page 6-4,
Steps 4 through 8.
I WARNING
The threads on the Button Head Cap screws and Allen screws #1 and #2 have been treated with Vibra-TITE® VC-3,
a locking and sealing coating, to reduce the possibility that they will become loose. You should be able to adjust the
cams and/or sideguards approximately four times without reapplying the coating to these screws. If you repeatedly
adjust the cams or remove the sideguard, TiLite requires that you reapply Vibra-TITE® VC-3 after every fourth
adjustment. If you ignore this Warning, you could fall, tip over or lose control of the wheelchair and seriously injure
yourself or others or damage the wheelchair.
Aero T/TRA Owner's Manual
Figure 6-6
Mounting/ Adjusting/ Removing
Spacer
Button Head
Cap Screw
Allen
Screw #2
CHAPTER 6: SIDE GUARDS
Back
Mount
Seat
Tube
Outer
Clamp
Front Cam
Conical Washer
6-5
Allen
Screw #3
Washer
Inner
Clamp
OM_Aero T_TRA_0414RevB