Titanium Open Loop Footrest; Angle Adjustable Footrest; Adjusting The Angle - TiLite TRA AERO T Owner's Manual

Figure 3-3
Footrest Height Adjustment

Titanium Open Loop Footrest

The Titanium Open Loop Footrest (see Figure 3-5) can be replaced or the height adjusted by using the tools and
following the procedures under "Titanium Footrest with Flat ABS Cover - Adjusting the Height/Replacing" on page 3-2.

Angle Adjustable Footrest

Adjusting the Angle

Tools needed:
• 5/32" Allen Wrench
1. Loosen, but do not remove, the two Allen screws that secure the footplate to the clamp. See Figure 3-6.
2. Adjust the footrest to desired angle.
3. Tighten the Allen screws, making sure the screws and the locknuts are secure and will not permit the footplate to
move up or down under weight.
Aero T/TRA Owner's Manual
Frame
Figure 3-5
Titanium Open Loop Footrest
3-3
CHAPTER 3: FOOTRESTS
Figure 3-4
Footrest Height Adjustment
Footrest
OM_Aero T_TRA_0414RevB