Compact Pull To Lock; Adjusting; Replacing - TiLite TRA AERO T Owner's Manual

CHAPTER 10: WHEEL LOCKS

Compact Pull to Lock

Adjusting

Tools Needed:
• 3/16" Allen Wrench
1. Loosen, but do not remove, the Allen screws in the wheel lock clamp. See Figure 10-2.
2. Adjust the position of the wheel lock clamp on the frame so the wheel stop embeds at least 3/16" into the tire
when engaged in the locked position.
3. Securely tighten the two Allen screws that secure the wheel lock clamp to the frame.

Replacing

Tools Needed:
• 3/16" Allen Wrench
1. Loosen, but do not remove, the two Allen screws that secure the wheel lock clamp to the frame. See Figure 10-2.
2. Slide the wheel lock out of the clamp.
3. Slide the new wheel lock into the wheel lock clamp, but do not tighten the Allen screws.
4. Follow the procedures under "Compact Pull to Lock - Adjusting" on page 10-2 to position and secure the new
wheel lock.
Compact Push to Lock and Compact Pull to Lock Wheel Locks with Extension
Handles
All of the adjustments set forth under "Compact Push to Lock and Compact Pull to Lock" on pages 10-1 to 10-2 apply
to the Compact Push to Lock and Compact Pull to Lock Wheel Locks with Extension Handles.
Composite Scissor Lock
Adjusting
Tools Needed:
• 3/16" Allen Wrench
1. Loosen, but do not remove, the Allen screws in the wheel lock clamp. See Figure 10-3.
2. Adjust the position of the wheel lock clamp on the frame so the wheel stop embeds at least 3/16" into the tire
when engaged in the locked position.
3. Securely tighten the two Allen screws that secure the wheel lock clamp to the frame.
Aero T/TRA Owner's Manual
Figure 10-2
Adjusting/Replacing the Pull to Lock
Wheel Lock
Clamp
Tire
10-2
Allen
Screws
Frame
Wheel Stop
OM_Aero T_TRA_0414RevB