Appendix B. Power Cord Set Requirements - Compaq Prolinea Family Maintenance & Serice Manual

Appendix B. Power Cord Set Requirements

The voltage select switch feature on the computer permits it to operate
from any line voltage between 100 - 120 or 220 - 240 volts AC.
The power cord set received with the computer meets the requirements for
use in the country where you purchased the equipment.
Power cord sets for use in other countries must meet the requirements of
the country where you use the computer. For more information on power cord
set requirements, contact your Authorized Compaq Reseller or Service
Provider.
General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 6.00 feet (1.8 m) and
a maximum of 9.75 feet (3.0 m).
2. All power cord sets must be approved by an acceptable accredited agency
responsible for evaluation in the country where the power cord set will
be used.
3. The power cord set must have a minimum current capacity of 10A and a
nominal voltage rating of 125 or 250 volts AC, as required by each
country's power system.
4. The appliance coupler must meet the mechanical configuration of an EN
60 320/IEC 320 Standard Sheet C13 connector, for mating with appliance
inlet on the Switch Box.
Country-Specific Requirements
Power Cord Set Requirements By Country
===========================================================================
Country
===========================================================================
Australia
Austria
Belgium
Canada
Denmark
Finland
France
Germany
Italy
Accredited Agency
EANSW
OVE
CEBC
CSA
DEMKO
SETI
UTE
VDE
IMQ
Applicable Note Numbers
1
1
1
2
1
1
1
1
1