Compaq Prolinea Family Maintenance & Serice Manual page 115

4. Install the replacement lock by snapping it into place as shown in
Figure 5-35.
Chapter 5.10 Speaker
The speaker is mounted on the front chassis panel of CDS models. The
speaker and its mounting bracket are installed as a unit but you must
retain the speaker bracket for reassembly. To remove and replace the
speaker, complete the following steps:
1. Complete the steps in Section 5.3 to prepare the computer for
disassembly.
2. Complete the steps in Unit Cover Removal and Replacement in Section 5.4
to gain access to the speaker.
NOTE: If the Enhanced Business Audio Board is installed in the option
slot, the speaker cable is connected to the connector on the
backplane board. If the Enhanced Business Audio Board is installed
in an expansion slot, the speaker cable is connected to the
connector on the Enhanced Business Audio Board.
3. Disconnect the speaker cable from its connector on the backplane
(Figure 5-36).