Sony SR-R1 Operation Manual page 66

Setting Item
MON SEL (3D)
LUT
For details on LUT
file operation, see
"Monitor LUT
Function" (page 92).
66
VIDEO Setup Menu
SPLIT (H)
SPLIT (V)
BORDER
LUT MODE
LUT STATUS
LUT LOAD
LUT SAVE
LUT RESET
Settings
Sets the split position when the SPLIT MODE is set to a
horizontal split.
0 to [50] to 100%
Sets the split position when the SPLIT MODE is set to a
vertical split.
0 to [50] to 100%
Specifies the setting for the borders that appear when
split-screen display for monitor outputs is enabled in
SPLIT MODE.
OFF [Off]: Does not display borders.
WHITE [White]: Displays white borders.
BLACK [Black]: Displays black borders.
Selects whether or not to use LUT, and when LUT is
used, selects the bank in which the LUT file is stored.
OFF [Off]: Does not perform LUT conversion.
BANK0 [Bank 0]: Selects the LUT file in bank 0.
BANK1 to BANK3 [Bank 1 to Bank 3]: Selects the LUT
file in any of bank 1, bank 2, and bank 3.
FtH [Full to Head]: Does not use a LUT file and instead
adjusts signals that exceed the HD video level range
a)
(4 to 1,019 steps) to match the standard video levels
from 64 (0% black) to 940
then displays them.
a)
During 10-bit signal level
Note
Keep in mind that LUT conversion is performed in
respect to the main output.
Displays a list of the LUT files in the banks. The currently
selected file is displayed in yellow. You can select a file
and then display a simple I/O curve, and delete
unnecessary LUT files from banks.
Loads a LUT file from a "Memory Stick" to a bank.
Saves a LUT file from a bank to a "Memory Stick."
Deletes all of the LUT files in Bank 0 to Bank 3.
a)
(100% white) steps and