Sony SR-R1 Operation Manual page 82

Warning messages
Code Message
W001 PB FREQ
MISMATCH
W002 PB FMT
MISMATCH
W003 CANNOT
REC REV
W006 SDI INGEST
MODE
W007 REC INHIBIT
MODE
W009 TEMPERATURE
LOW
W00C CP MISSING
W00D DC VOLTAGE
LOW
W00E BOARD
TEMP HIGH
W010 MEDIA FULL Cannot record because
W011 TOO MANY
FILES
W012 COND3 BAD
W013 LID OPEN
W014 VPID FERQ
MISMAT
82
Error Messages and Warning Messages
Meaning
There is a mismatch
between the configured
system frequency and the
frequency information
recorded on the playback
file.
There is a mismatch
between the configured
system format and the
format information
recorded on the playback
file.
The last recorded file
cannot be played back.
Recording cannot start
due to SDI INGEST
mode being enabled.
Unit is in a non-record
mode or SYSTEM
settings are being
configured.
The temperature within
the unit has fallen below
the rated value. Warm-up
the unit.
Cannot detect a signal
from the control panel.
Detected a drop in the
supply voltage.
The temperature inside
the unit is too high.
the SRMemory card is
full.
The number of files on
the SRMemory card
exceeds the maximum
value.
Cannot record due to
insufficient bad memory
swap area on the
SRMemory card.
The SRMemory card
insertion slot lid is open.
The VPID frequency
information does not
match that of the system.
Code Message Meaning
W015 VPID C-SP The color space
information in the video
payload identifier
(VPID) of the input
signal and the SYSTEM
settings (444/422) do not
match.
W016 VPID LINK The LINKA/B
information in the video
payload identifier
(VPID) of the input
signal and the connectors
used do not match.
W017 MEDIA Detected an SRMemory
REMOVED card connection failure.
W018 MARK IN Previous MARK IN data
FULL was overwritten due to
the limit on the number
of MARK IN points for a
single file being
exceeded.
W019 ILLEGAL A file name containing
FILENAME prohibited characters was
received from the PMW-
F3. Rename the file.
W01C X2 ORDER The 50ix2 and 59ix2 data
MISMAT sequence of the HD SDI
input is incorrect. Check
the settings on the
camera.
W01D VPID BIT The bit length of the HD
MISMAT SDI input's Video
Payload ID and the 10
bit/12 bit setting of the
system format do not
match.
W022 AUDIO PLL The audio clock is not
UNLOCK locked to the reference
video signal.
W028 SDI RMT IN Detected an error in the
NG SDI REMOTE
information for the HD
SDI input.
W029 SYNC REC A synchronization error
NG was detected in the start
time for SYNCHRO
REC. Check for
consistency with the
camcorder's TC.
W02F LOST LOCK Detected a loss of lock
synchronization during
recording or playback.