Avaya 3641 Installation, Configuration And Administration page 64

Part B: Avaya 3641/3645 Wireless IP Telephone
The Delete [PAC/Cert.] option removes expired credentials from the phone. When
the authentication method is EAP-FAST the PAC on the phone is deleted. If the
RADIUS server has enabled "anonymous in-band PAC provisioning", then the phone
will automatically re-acquire these credentials from the RADIUS server over the air.
When the authentication method is PEAP or EAP-FAST manual provisioning, the
credential on the phone is deleted and a new one needs to be downloaded through the
HAT. When the authentication method is PEAP the certificate on the phone is deleted
and a new certificate needs to be downloaded through the HAT. See WPA2 Enterprise
PEAP Certificate Enrollment and EAP-FAST Manual PAC Provisioning at the end of
this chapter.
"Restore Defaults" will remove the certificates from the phone.
Custom – QoS
The Mode may be set to either *SVP or Wi-Fi Standard. SVP mode uses the AVPP
Server to provide enterprise-grade QoS. DSCP tags are used to change the priority
settings for various classes of packets as they are transmitted to the network from the
handset. Default values are given but may be overwritten: WT in call = 46, WT
standby = 46, Other = 0.
Wi-Fi Standard mode uses standards-based traffic controls WMM, WMM Power Save
and WMM Admission Control for QoS, in place of the AVPP Server. DSCP tags are
used to change the priority settings for various classes of packets as they are
transmitted to the network from the handset. Default values are given but may be
overwritten: Voice = 46, Control = 46, Other = 0.
Admission Cntrl is used to enable and disable the use of WMM Admission Control by
the handset for the AC_VO and AC_VI access categories. If the WLAN is using WMM
Admission Control, the handset should be set to *Mandatory. If the WLAN is not
using WMM Admission Control, the handset should be set to *Optional. See Best
Practices Guide for Deploying SpectraLink 8020/8030 Wireless Telephones for a
detailed explanation of the use of WMM Admission Control.
CCX
CCX settings configure the handset for operation as a CCX V4 client.
WPA2-Enterprise
The Authentication setting can select either *EAP-FAST or PEAP as the
authentication method for RADIUS server. The following authentication servers have
been validated for use with R3.0:
• Juniper Networks Steel-belted Radius Enterprise Edition (formerly Funk), v6.1
•
Microsoft Internet Security and Acceleration (ISA) Server 2003
•
Cisco Secure Access Control Server (ACS), v4.1
•
FreeRADIUS v2.0.1 and 1.1.7
Other RADIUS servers will likely work properly with the handsets, but have not been
tested. Inquiries on untested servers will receive limited, "Best Effort", support.Note
that for Fast Handoff, the only selection available is *CCKM.
Username: Enter a username that matches an entry on your RADIUS server.
Alphanumeric strings can be entered using the alphanumeric string entry technique.
Password: Enter the password that corresponds to this username.
64 Avaya Voice Priority Processor, Avaya 3641/3645 Wireless IP Telephone, Handset Administration Tool