Avaya 3641 Installation, Configuration And Administration page 16

Part A: Avaya Voice Priority Processor
1. Remove the corner screws from the AVPP.
2. Screw the U-shaped end (round screw holes) of the two mounting plates to the AVPP.
3. Screw the other end of the two mounting plates (oblong screw holes) to the rack.
4. Repeat steps 1-3 for each additional AVPP. The mounting plate is designed to provide
the correct minimum spacing between units. When mounting multiple units, stack the
units in the rack as closely as possible.
Mount the Avaya Voice Priority Processor to a wall
The Avaya Voice Priority Processor can be mounted either horizontally or vertically.
To mount the Avaya Voice Priority Processor to a wall:
1. Using a 1/8" drill bit, drill four pilot holes, on 1.84" by 12.1" centers (approximately
equivalent to 1-13/16" by 12-1/8").
2. Insert the #8 x 3/4" screws in the pilot holes and tighten, leaving a 1/8" to 1/4" gap
from the wall.
Grounding Instructions
Safety Warning
All system units must be grounded to a protective earth by means of the grounding stud
located on the rear panel. Refer to the illustration below for recommended continuity
connection.
No more than 15 units may be grounded through one connection to the protective earth
ground. Systems involving more than 15 units must be broken up into groups of 15 or
fewer units with each group provided with an independent protective earthing conductor.
Connect Avaya Voice Priority Processor to LAN
Using a Cat. 5 cable, connect the NETWORK port on the Avaya Voice Priority Processor to
the connecting port on the Ethernet switch.
16
The metal chassis of this unit may contain leakage currents (i.e., "touch"
current) which is cumulative when multiple units are connected together to
form a system. To prevent the summation of leakage currents from being
present on exposed metal surfaces, the following installation procedure must be
followed.
Avaya Voice Priority Processor, Avaya 3641/3645 Wireless IP Telephone, Handset Administration Tool