Avaya 3641 Installation, Configuration And Administration page 142

Part D: Appendices
Message Description
No Gateway IP The Wireless IP Telephone is configured for
static IP addresses and no valid unicast IP
address is assigned for gateway configuration.
No Host IP (Addr) The Wireless IP Telephone is configured for
"static IP" (as opposed to "use DHCP") and no
valid host IP address (the Wireless IP
Telephone's IP address) has been entered.
No IP Address Invalid IP.
No Net Access Cannot authenticate / associate with AP.
No Net Found Wireless IP Telephone cannot find any APs and
No APs has no additional information to display as to
why. Possible problems are enumerated
below.
No radio link.
No SSID – Incorrect SSID.
AP does not support appropriate data rates.
Out of range.
Incorrect security settings
No Net Found The Wireless IP Telephone is configured for
No CCX APs CCX compatible operation, but cannot find an
access point that is advertising CCX
capability.
No Net Found The Wireless IP Telephone is configured to use
No CCKM APs CCKM for fast and secure handoffs, but cannot
find an access point that is configured
appropriately.
No Net Found The Wireless IP Telephone is configured to use
No WMM APs
Wi-Fi Standard QoS, but cannot find an AP
configured appropriately.
No Net Found x...x – AP MAC address.
xxxxxxxxxxxx yy yy – AP signal strength.
Wireless IP Telephone cannot find a suitable
access point; displays MAC and signal
strength of "best" non-suitable AP found.
142 Avaya Voice Priority Processor, Avaya 3641/3645 Wireless IP Telephone, Handset Administration Tool
Action
Configure a valid IP address in Admin
menus.
Enter a valid IP address in the configuration
settings or change to "use DHCP".
Check the IP address of the Wireless IP
Telephone and re-configure if required.
Verify the AP configuration.
Verify that all the WEP settings in the
Wireless IP Telephone match those in the
APs.
Verify that the AP is turned on.
Verify the SSID of the wireless LAN and
enter.
Check the AP configuration against
configuration document for AP.
Try getting closer to an AP. Check to see if
other Wireless IP Telephones are working
within the same range of an AP. If so, check
the SSID of this Wireless IP Telephone.
Verify that all the Security settings in the
Wireless IP Telephone match those in the
APs.
Check the AP configuration against VIEW
Configuration Guide for AP.
Check the AP configuration against VIEW
Configuration Guide for AP.
Check the AP configuration against VIEW
Configuration Guide.
Check AP and handset network settings
such as SSID, Security, Reg domain and Tx
power.
Ensure APs are configured per VIEW
Configuration Guide.
Try Site Survey mode to determine more
specific cause.