Riding Tips; Starting The Engine - HYOSUNG GV250 Ei Owner's Manual

RIDING TIPS

STARTING THE ENGINE

Before attempting to
start the engine make
sure :
1. Inspect every day once before riding
the motorcycle.
2. The transmission is in neutral.
3. The fuel cock lever is in the "ON"
position. (Only for
4. The ignition switch is in the "ON"
position.
5. The engine stop switch is in the "
position.
6. Moving the side stand to the fully
upper position.
7. Squeeze the clutch lever.
WARNING
The
equipped with the side stand ignition
interlock system.
1. If the transmission is in neutral, you
can start the engine regardless of
clutch lever and side stand.
2. If the transmission is not in neutral,
you can only start the engine with
pulling in clutch lever and side stand
up.
Make sure that the side stand igintion
interlock system is working properly
before riding.
)
"
& are
The
on the head lamp, meter lamp, tail
lamp and license plate lamp when
the ignition switch is turned to the
"ON" position.
The
the head lamp and meter lamp when
the ignition switch is turned to the
"ON" position.
WARNING
Running the engine indoors or in a
garage can be hazardous.
Exhaust gas contains carbon monoxide,
a gas that is colorless and odorless and
can cause death or severe injury.
Only run the engine outdoors where
there is a fresh air.
Running the engine too long without
riding may cause the engine to
overheat.
Overheating can result in damage to
internal engine components and
discoloration of exhaust pipes.
Shut the engine off if you cannot begin
your ride promptly.
43
CAUTION
always comes
always comes on
CAUTION