HYOSUNG GV250 Ei Owner's Manual page 43

7. Before replacing the engine oil filter cap
, be sure to check that the engine oil
filter spring
installed correctly. Use new "O" ring
each time the engine oil filter element is
replaced.
8. Replace the oil filter cap
the nuts securely but do not over tighten
them.
9. Replace the drain plug and tighten it
securely. At this time, insert the gasket
necessarily.
10. Pour fresh engine oil through the
engine oil filler hole. Approximately
1,500 of the engine oil will be
required.
CAUTION
Approximately 1,450
must be required when changing engine
oil only without replacing the oil filter.
CAUTION
In case of the engine oil pouring
excessively, the engine output being
made insufficient.
Be careful not to pour engine oil.
11. Install the engine oil filler plug.
CAUTION
Failure to use the correct oil can damage
your motorcycle.
Engine damage may occur if you use the
engine oil that does not meet Hyosung's
specifications.
Be sure to use the engine oil specified in
the FUEL AND OIL RECOMMENDATION
section.
and the "O" ring
and tighten
of engine oil
12. Start the engine and allow it idle for a
few minutes. Check to see that no the
engine oil is leaking from the oil filter
are
cap and drain plug.
13. Check the oil level according to Engine
Oil Level Check procedure.
Engine oil leaks from around the oil filter
cap or drain plug indicate incorrect
installation or "O" ring / gasket damage.
If you find any leaks or are not sure that
the oil filter cap / drain plug has been
properly installed, have the motorcycle
inspected by your Hyosung dealer or
qualified mechanic.
42
CAUTION