Air Cleaner - HYOSUNG GV250 Ei Owner's Manual

BATTERY INSTALLATION
installation order pay attention to following
points :
Battery wire
1. Remove the front seat, right frame cover
and battery support.
2. Lay down positive terminal of the
battery at leftside of the battery case (on
the motorcycle).
3. Connect positive battery wire at the
battery terminal.
4. Put on the rubber cap at the
terminal of the battery.
5. Install negative battery wire at the
battery terminal.
6. Install the battery support, right frame
cover and front seat.
CAUTION
If connect first the battery wire at the
battery then lay down at the battery
case, will be installed the opposite
direction [ positive terminal face on
the rightside of the motorcycle] as that
length of the
something extra.
This time, the battery could not lay down
perfectly and to occur the short circuit
etc. if the battery install the opposite
direction.
& 's battery
Front side
positive
battery wire has no

AIR CLEANER

The air cleaner is located inside the right
air cleaner cover.
If the air cleaner element has become
clogged with dust, intake resistance will
increase with a resultant decrease in power
output and an increase in fuel consumption.
If riding under severe conditions must be
cleaned or replaced more frequently than
maintenance schedule. Check and clean
the air cleaner element periodically
according to the following procedure.
Never operate the engine without the
element in position.
Operating the engine without the air
cleaner element will increase engine
wear. Always be sure that the air cleaner
element is in excellent operational
condition.
The life of the engine depends largely on
this single component.
If the air cleaner element is polluted, will
occur to starting go out, output
insuffiency, combustion effiency
decline, and sooty smoke (black
smoke).
This appearence is occurred at first to
clean the air cleaner element and
confirm.
61
CAUTION
CAUTION