HYOSUNG GV250 Ei Owner's Manual page 46

CAUTION
After three seconds whenever the
ignition switch is set to "ON" position,
"FI" check lamp "
If this lamp stays on during normal
operation, it means that the electric fuel
injection system is not operating
correctly. Stop the engine immediately
and contact an authorized Hyosung
dealer. Do not use the motorcycle with
disabled electrical fuel injection system,
in order to avoid damaging the engine
components.
" must goes out.
WHEN THE
STARTING :
When the engine is cold :
If the ambient temperature is below 5 C
(40 F ) :
1. Pull the choke lever to the ENGAGE
position.
2. Apply the rear brake pedal.
3. Squeeze the clutch lever and push the
electric starter switch.
4. Immediately after the engine starts, return
the choke lever halfway.
5. When the engine is sufficiently warmed
up, move the choke lever to the "OFF"
position.
If the ambient temperature is at or above
5 C (40 F ) :
1. Pull the choke lever to the ENGAGE
position halfway.
2. Apply the rear brake pedal.
3. Squeeze the clutch lever and push the
electric starter switch.
4. When the engine is sufficiently warmed
up, move the choke lever to the "OFF"
position.
N O T E
If the ambient temperature is above 20 C
(68 F), operation of the choke is not
necessary to start the engine.
Operation of the choke can make the
engine hard to start due to too rich
fuel/air mixture.
45