HYOSUNG GV250 Ei Owner's Manual page 85

WHEN THE ENGINE REFUSES
TO START
FUEL SUPPLY CHECK
Only for
If the engine refuses to start, perform the
following inspections to determine the
cause.
Is there enough fuel in the fuel tank?
Is the fuel reaching the carburetor from
the fuel cock?
Disconnect the fuel hose from the
carburetor, turn the fuel cock lever to
the "ON" position and see if gasoline flows
from the fuel hose.
If it has been determined that fuel is
reaching the carburetor, the ignition
system should be checked next.
CAUTION
Do not allow the fuel to spill.
Catch the fuel in container.
Do not allow any fuel to come in contact
with the hot engine or exhaust system.
Extinguish any smoking materials
before performing this check, and stay
away from any other fire or heat source.
IGNITION SYSTEM CHECK
1. Remove the spark plug and reattach it to
the spark plug lead.
2. Put the engine stop switch in the "
position and ignition switch in the ON
position. Holding the spark plug base
firmly against the engine, the
transmission in neutral, the side stand
up, the clutch disengaged and push the
electric starter switch. If the ignition
system is operating properly, a blue
spark should jump across the spark plug
gap.
3. If there is no spark, clean the spark plug.
Replace it if necessary. Retry the above
procedure with the cleaned spark plug or
new one.
4. If there is still no spark, consult your
Hyosung dealer for repairs.
84
&
"