HYOSUNG GV250 Ei Owner's Manual page 32

CAUTION
Put out the hazard warning switch
directly after used.
If the motorcycle ride with the hazard
warning switch turned on condition,
other driver confuse and the battery's
service life is shortened as electrical
consumption.
CAUTION
The
the head lamp, meter lamp, tail lamp and
license plate lamp when the ignition
switch is turned to the "ON" position.
LIGHT SWITCH
Only for
" " position
: The tail lamp and license plate lamp
come on.
" " position
: The tail lamp and license plate lamp
go off.
CAUTION
The
head lamp and meter lamp when the
ignition switch is turned to the "ON"
position.
STARTER SWITCH
Use this switch to operate the starting
motor.
With the ignition switch in the "ON"
position, the engine stop switch in the
" " position, and the transmission is in
neutral, pull in the clutch lever and side
stand up and push the starter switch to start
the engine.
always comes on
always comes on the
's "FI" check lamp
comes on for about three seconds
whenever the ignition switch is set to "ON"
position, and go off after three seconds.
In case of
starter switch to start the engine after go off
the "FI" check lamp.
In case of
starter switch when "FI" check lamp is
come on, the engine will be started
badly and the spark plugs get wetted.
Take off the starter switch right after
started.
Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after
several attempts, check the fuel
supply and igintion system.
(Refer for Page 83)
WARNING
The
equipped with the side stand ignition
interlock system.
1. If the transmission is in neutral, you
can start the engine regardless of
clutch lever and side stand.
2. If the transmission is not in neutral,
you can only start the engine with
pulling in clutch lever and side stand
up.
Make sure that the side stand igintion
interlock system is working properly
before riding.
31
, push the
CAUTION
, if push the
CAUTION
& are