Riding Tips; Starting The Engine - HYOSUNG GT650 Owner's Manual

RIDING TIPS

STARTING THE ENGINE

Before attempting to
start the engine make
sure :
1. Inspect every day once before riding
the motorcycle.
2. The transmission is in neutral.
3. The ignition switch is in the "ON"
position.
4. The engine stop switch is in the "
position.
5. Moving the side stand to the fully
upper position.
6. Squeeze the clutch lever.
N O T E
Push the starter switch after about three
seconds whenever the ignition switch is
set to "ON" position with engine
stopped as a test of the electric injection
system operation.
If push the starter switch before about
three seconds, the engine will be started
badly and the spark plugs get wetted.
The
with the side stand ignition interlock
system.
If the transmission is in neutral or the
side stand up, you can only start the
engine with pulling in the clutch lever.
This side stand ignition interlock system
prevents the motorcycle from being
started with side stand down.
Make sure that the side stand igintion
interlock system is working properly
before riding.
"
These motorcycles always come on the
head lamp, position lamp, meter lamp,
tail lamp and license plate lamp when
the ignition switch was turned to the
"ON" position .
Running the engine indoors or in a
garage can be hazardous.
Exhaust gas contains carbon monoxide,
a gas that is colorless and odorless and
can cause death or severe injury.
Only run the engine outdoors where
there is a fresh air.
Running the engine too long without rid-
ing may cause the engine to overheat.
Overheating can result in damage to
internal engine components and discol-
oration of exhaust pipes.
Shut the engine off if you cannot begin
your ride promptly.
53 53
WARNING
are equipped
CAUTION
WARNING
CAUTION