HYOSUNG GV250 Ei Owner's Manual page 81

CAUTION
The
on the head lamp, meter lamp, tail
lamp and license plate lamp when the
ignition switch is turned to the "ON"
position.
The
the head lamp and meter lamp when
the ignition switch is turned to the
"ON" position.
REPLACEMENT OF THE LAMP
Requirement electric power of the lamp
shown in the following chart.
When replace the damaged lamp, always
use the equal capacity.
The use of a lamp other than rules may
cause to excessive at the electric system or
to damage the lamp.
NAMES
HI
Head lamp
LO
Brake / Tail lamp
Turn signal lamp
License plate lamp
CAUTION
The use of a lamp other than rules may
cause to occur the vehicle fire and to
damage electric parts.
Surely use only the lamp of proper
capacity.
always comes
always comes on
CAPACITY
12V - H4 : 60W 1
12V - H4 : 55W 1
12V - P21 / 5W 1
12V - RY10W 4
12V - W5W 1
HEAD LAMP'S BULB
REPLACEMENT
1. Remove the two screw
left) and the head lamp assembly.
2. Disconnect the socket
head lamp.
3. Remove the rubber cap
4. Umhook the bulb holder spring
remove the bulb
5. To install the head lamp, reverse the
above sequence.
80
(right and
from the
.
and
.