Dell SonicWall SRA 4200 Administrator's Manual page 295

•
•
•
You can configure one of the above settings for each of the following portal features:
•
•
•
•
•
•
•
•
Click Accept.
Step 2
Modifying User NetExtender Settings
This feature is for external users, who will inherit the settings from their assigned group upon
login. NetExtender client settings can be specified for the user, or use the group settings. For
information about configuring group settings, see
To enable NetExtender ranges and configure DNS and client settings for a user, perform the
following steps:
Navigate to Users > Local Users.
Step 1
Click the configure icon next to the user you want to configure.
Step 2
In the Edit Local User page, select the NxSettings tab.
Step 3
Enter a beginning IPv4 address in the Client Address Range Begin field.
Step 4
Enter an ending IPv4 address in the Client Address Range End field.
Step 5
Enter a beginning IPv6 address in the Client IPv6 Address Range Begin field.
Step 6
Enter an ending IPv6 address in the Client IPv6 Address Range End field.
Step 7
Under NetExtender DNS Settings, type the address of the primary DNS server in the Primary
Step 8
DNS Server field.
Optionally type the IP address of the secondary server in the Secondary DNS Server field.
Step 9
Type the DNS domain suffix in the DNS Domain field.
Step 10
For SRA appliances supporting connections from Apple iPhones, iPads, or other iOS devices
using Dell SonicWALL Mobile Connect, the DNS Domain is a required field. This DNS domain
is set on the VPN interface of the iPhone/iPad after the device makes a connection to the
appliance. When the mobile device user accesses a URL, iOS determines if the domain
matches the VPN interface's domain, and if so, uses the VPN interface's DNS server to resolve
the hostname lookup. Otherwise, the Wi-Fi or 3G DNS server is used, which will not be able to
resolve hosts within the company intranet.
Under NetExtender Client Settings, select one of the following from the Exit Client After
Step 11
Disconnect drop-down list:
Use group setting – The setting defined in the group to which this user belongs will be used
to determine if the portal feature is enabled or disabled. Group settings are defined by
configuring the group in the Users > Local Groups page.
Enabled – Enable this portal feature for this user.
Disabled – Disable this portal feature for this user.
NetExtender – Because Mobile Connect acts as a NetExtender client when connecting to
the appliance, this setting applies to both NetExtender and Mobile Connect.
Launch NetExtender after login
File Shares
Virtual Assist Technician
Virtual Assist Request Help
Virtual Access Setup Link
Allow User to Add Bookmarks
Allow User to Edit/Delete Bookmarks – Applies to user-owned bookmarks only.
"Editing Group Settings" section on page
Users Configuration | 295
316.