Define the end-of-job confirmation
Introduction
To help the non-experienced user, you can define a supplementary user request
to finish the jobs with different job parts. To assemble the job parts, the user
must press the combine key
. If you enable the end-of-job confirmation, the user gets a second request to
press the start Key .
You can also use the Océ System configuration to define the end-of-job
Note:
confirmation.
Before you begin
Enter the key operator system.
1.
Illustration
[18] Enable the end-of-job confirmation
[18] Enable the end-of-job confirmation
Defining the end-of-job confirmation
Activate the 'Machine' section.
1.
Open the 'Error information' card.
2.
Press the 'End-of-job confirmation' function key to select 'Enabled' or
3.
'Disabled' .
Check
Exit the key operator system.
1.
To check the entered selection, make a copy job with different job parts.
2.
Set the defaults
and confirm the end of the job with the start key
35