Chapter 18 Static Route; Static Route Overview; Configuring Ip Static Route; Figure 149 Example Of Static Routing Topology - ZyXEL Communications ZyWall 70 User Manual

This chapter shows you how to configure static routes for your ZyWALL.

18.1 Static Route Overview

Each remote node specifies only the network to which the gateway is directly connected, and
the ZyWALL has no knowledge of the networks beyond. For instance, the ZyWALL knows
about network N2 in the following figure through remote node Router 1. However, the
ZyWALL is unable to route a packet to network N3 because it doesn't know that there is a
route through the same remote node Router 1 (via gateway Router 2). The static routes are for
you to tell the ZyWALL about the networks beyond the remote nodes.

Figure 149 Example of Static Routing Topology

18.2 Configuring IP Static Route

Click STATIC ROUTE to open the IP Static Route screen (some of the screen's blank rows
are not shown).
Note: The first two static route entries are for default WAN1 and WAN2 routes and
cannot be modified or deleted. The name of each default static route is left
blank unless you configure a static WAN IP address.

Chapter 18 Static Route

C
H A P T E R
Static Route
ZyWALL 70 User's Guide
1 8
315