ZyXEL Communications ZyWall 70 User Manual page 107

Table 23 Bridge (continued)
LABEL
Rapid Spanning Tree
Protocol Setup
Enable Rapid Spanning
Tree Protocol
Bridge Priority
Bridge Hello Time
Bridge Max Age
Forward Delay
Bridge Port
RSTP Active
RSTP Priority
0(Highest)~240(Lowest)
RSTP Path Cost
1(Lowest)~65535(Highes
t)
Apply
Reset
Chapter 5 Bridge Screens
DESCRIPTION
Select the check box to activate RSTP on the ZyWALL.
Enter a number between 0 and 61440 as bridge priority of the ZyWALL. 0 is
the highest.
interval (between 1 and 10) in seconds that the root bridge
Enter an
waits before sending a hello packet.
(between 6 and 40) in seconds
Enter an interval
get a Hello BPDU from the root bridge.
(between 4 and 30) in seconds
Enter the length of time
remains in the listening and learning port states. The default is 15 seconds.
This is the bridge port type. Port types are: WAN, LAN, WLAN and DMZ.
Select the check box to enable RSTP on the corresponding port.
Enter a number between 0 and 240 as RSTP priority for the corresponding
port. 0 is the highest.
Enter a number between 1 and 65535 as RSTP path cost for the
corresponding port. 65535 is the highest.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
ZyWALL 70 User's Guide
that a bridge waits to
that a bridge
107