Mac Address Filter Setup - ZyXEL Communications ZyWall 70 User Manual

Table 172 Menu 3.5: Wireless LAN Setup
FIELD
RTS
Threshold
Frag.
Threshold
WEP
Default Key
Key 1 to Key
4
Edit MAC
Address Filter
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
Note: The ZyWALL LAN Ethernet and wireless ports can transparently communicate
with each other (transparent bridge).

29.5.1 MAC Address Filter Setup

Your ZyWALL checks the MAC address of the wireless station device against a list of
allowed or denied MAC addresses. However, intruders could fake allowed MAC addresses so
MAC-based authentication is less secure than EAP authentication.
Follow the steps below to create the MAC address table on your ZyWALL.
1 From the main menu, enter 3 to open Menu 3 - LAN Setup.
2 Enter 5 to display Menu 3.5 - Wireless LAN Setup.
3 In the Edit MAC Address Filter field, press [SPACE BAR] to select Yes and press
[ENTER]. Menu 3.5.1 - WLAN MAC Address Filter displays as shown next.
Chapter 29 LAN Setup
DESCRIPTION
(Request To Send) The threshold (number of bytes) for enabling RTS/CTS handshake.
Data with its frame size larger than this value will perform the RTS/CTS handshake.
Setting this attribute to be larger than the maximum MSDU (MAC service data unit) size
turns off the RTS/CTS handshake. Setting this attribute to zero turns on the RTS/CTS
handshake. Enter a value between 0 and 2432.
The threshold (number of bytes) for the fragmentation boundary for directed messages.
It is the maximum data fragment size that can be sent. Enter a value between 256 and
2432.
Select Disable to allow wireless stations to communicate with the access points without
any data encryption.
Select 64-bit WEP or 128-bit WEP to enable data encryption.
Enter the key number (1 to 4) in this field. Only one key can be enabled at any one time.
This key must be the same on the ZyWALL and the wireless stations to communicate.
The WEP keys are used to encrypt data. Both the ZyWALL and the wireless stations
must use the same WEP key for data transmission.
If you chose 64-bit WEP in the WEP Encryption field, then enter any 5 ASCII
characters or 10 hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP in the WEP Encryption field, then enter 13 ASCII characters
or 26 hexadecimal characters ("0-9", "A-F").
Note: Enter "0x" before the key to denote a hexadecimal key. Don't
enter "0x" before the key to denote an ASCII key.
Press [SPACE BAR] to select Yes and then press [ENTER] to display menu 3.5.1.
ZyWALL 70 User's Guide
447