Configuring A Static Route Entry; Figure 148 Edit Ip Static Route; Table 100 Edit Ip Static Route - ZyXEL Communications ZyWALL 5 User Manual

Hide thumbs Also See for ZyWALL 5:

Table of Contents

Table 99 IP Static Route

18.2.1 Configuring a Static Route Entry

Select a static route index number and click Edit. The screen shown next appears. Fill in the

required information for each static route.

The following table describes the labels in this screen.

Destination IP

IP Subnet Mask

Chapter 18 Static Route

This is the IP address of the gateway. The gateway is a router or switch on the same

network segment as the device's LAN or WAN port. The gateway helps forward

packets to their destinations.

Select the radio button next to a static route index number and then click Edit to set

up a static route on the ZyWALL.

Select the radio button next to a static route index number and then click Delete to

remove a static route on the ZyWALL.

Enter the name of the IP static route. Leave this field blank to delete this static route.

This field allows you to activate/deactivate this static route.

This parameter specifies the IP network address of the final destination. Routing is

always based on network number. If you need to specify a route to a single host, use

a subnet mask of 255.255.255.255 in the subnet mask field to force the network

number to be identical to the host ID.

Enter the IP subnet mask here.

Enter the IP address of the gateway. The gateway is a router or switch on the same

network segment as the device's LAN or WAN port. The gateway helps forward

packets to their destinations.

ZyWALL 5 User's Guide