ZyXEL Communications ZyWall Reference Manual page 77

Table 27 Cellular Interface Commands (continued)
COMMAND
[no] network-selection {auto|home}
[no] budget active
[no] budget time active <1..672>
[no] budget data active {download-
upload|download|upload} <1..100000>
budget reset-day <0..31>
budget reset-counters
budget {log|log-alert}[recursive
<1..65535>]
no budget log [recursive]
budget new-connection {allow|disallow}
budget current-connection {keep|drop}
ZyWALL (ZLD) CLI Reference Guide
DESCRIPTION
Home network is the network to which you are originally subscribed.
Home has the 3G device connect only to the home network. If the
home network is down, the ZyWALL's 3G Internet connection is also
unavailable.
Auto is the default setting and allows the 3G device to connect to a
network to which you are not subscribed when necessary, for example
when the home network is down or another 3G base station's signal is
stronger. This is recommended if you need continuous Internet
connectivity. If you select this, you may be charged using the rate of a
different network.
Sets a monthly limit for the user account of the installed 3G card. You
can set a limit on the total traffic and/or call time. The ZyWALL takes
the actions you specified when a limit is exceeded during the month.
Use the no command to disable budget control.
Sets the amount of time (in hours) that the 3G connection can be
used within one month. If you change the value, the ZyWALL resets
the statistics. Use the no command to disable time budget control.
Sets how much downstream and/or upstream data (in Mega bytes)
can be transmitted via the 3G connection within one month.
download: set a limit on the downstream traffic (from the ISP to the
ZyWALL).
upload: set a limit on the upstream traffic (from the ZyWALL to the
ISP).
download-upload: set a limit on the total traffic in both directions.
If you change the value, the ZyWALL resets the statistics.
Use the no command to disable data budget control.
Sets the date on which the ZyWALL resets the budget every month. If
the date you selected is not available in a month, such as 30th or
31st, the ZyWALL resets the budget on the last day of the month.
Resets the time and data budgets immediately. The count starts over
with the 3G connection's full configured monthly time and data
budgets. This does not affect the normal monthly budget restart.
Sets the ZyWALL to create a log (log) or an alert log (log-alert) when
the time or data limit is exceeded. You can also specify how often
(from 1 to 65535 minutes) to generate a log or an alert.
Sets the ZyWALL to not create a log when the time or data limit is
exceeded. Specify recursive to have the ZyWALL only create a log
one time when the time or data limit is exceeded.
Sets to permit (allow) or drop/block (disallow) new 3G connections
when the time or data limit is exceeded.
Sets to maintain the existing 3G connection (keep) or disconnect it
(drop) when the time or data limit is exceeded. You cannot set budget
new-connection to allow and budget current-connection to drop at
the same time.
If you set budget new-connection to disallow and budget current-
connection to keep, the ZyWALL allows you to transmit data using the
current connection, but you cannot build a new connection if the
existing connection is disconnected.
Chapter 6 Interfaces
77