ZyXEL Communications ZyWall Reference Manual page 102

Chapter 8 Route
Table 44 Command Summary: Policy Route (continued)
COMMAND
[no] tunnel tunnel_name
[no] user user_name
policy6 {policy_number | append | insert
policy_number}
[no] bandwidth <1..1048576> priority
<1..1024> [maximize-bandwidth-usage]
[no] deactivate
[no] description description
[no] destination {address6_object|any} Sets the destination IPv6 IP address the matched packets must have.
[no] dscp {any | <0..63>}
[no] dscp class {default | dscp_class} Sets a DSCP class. Use default to apply this policy route to incoming
dscp-marking <0..63>
dscp-marking class {default |
dscp_class}
no dscp-marking
exit
[no] interface interface_name
[no] next-hop {auto|gateway gatewayv6
|interface interface_name |trunk
trunk_name|tunnel tunnel_name}
[no] schedule schedule_object
[no] service {service_name|any}
102
DESCRIPTION
Sets the incoming interface to an IPSec VPN tunnel. The
removes the IPSec VPN tunnel through which the incoming packets are
received.
Sets the user name. The no command resets the user name to the
default (any). any means all users.
Enters the IPv6 policy-route sub-command mode to configure, add or
insert a policy.
Sets the maximum bandwidth and priority for the policy. The no
command removes bandwidth settings from the rule. You can also turn
maximize bandwidth usage on or off.
Disables the specified policy. The no command enables the specified
policy.
Sets a descriptive name for the IPv6 policy. The no command removes
the name for the policy.
The no command resets the destination IP address to the default
(any). any means all IP addresses.
Sets a custom DSCP code point (0~63). This is the DSCP value of
incoming packets to which this policy route applies. any means all
DSCP value or no DSCP marker.
packets that are marked with DSCP value 0. Use one of the pre-
defined AF classes (including af11~af13, af21~af23, af31~af33, and
af41~af43) to apply this policy route to incoming packets that are
marked with the DSCP AF class.
The "af" entries stand for Assured Forwarding. The number following
the "af" identifies one of four classes and one of three drop
preferences. See Assured Forwarding (AF) PHB for DiffServ on page
104 for more details.
Sets a DSCP value to have the ZyWALL apply that DSCP value to the
route's outgoing packets.
Sets how the ZyWALL handles the DSCP value of the outgoing packets
that match this route. Set this to default to have the ZyWALL set the
DSCP value of the packets to 0. Set this to an "af" class (including
af11~af13, af21~af23, af31~af33, and af41~af43) which stands for
Assured Forwarding. The number following the "af" identifies one of
four classes and one of three drop preferences. See
Forwarding (AF) PHB for DiffServ on page 104
Use this command to have the ZyWALL not modify the DSCP value of
the route's outgoing packets.
Leaves the sub-command mode.
Sets the interface on which the matched packets are received. The no
command resets the incoming interface to the default (any). any
means all interfaces.
Sets the next-hop to which the matched packets are routed. The no
command resets next-hop settings to the default (auto).
Sets the schedule. The no command removes the schedule setting to
the default (none). none means any time.
Sets the IP protocol. The no command resets service settings to the
default (any). any means all services.
command
no
Assured
for more details.
ZyWALL (ZLD) CLI Reference Guide