ZyXEL Communications ZyWall Reference Manual page 224

Chapter 25 Device HA
Table 126 device-ha ap-mode Commands (continued)
COMMAND
[no] device-ha ap-mode interface_name
manage-ip ip subnet_mask
[no] device-ha ap-mode interface_name
activate
[no] device-ha ap-mode master sync
authentication password password
[no] device-ha ap-mode backup sync
authentication password password
[no] device-ha ap-mode backup sync
auto
[no] device-ha ap-mode backup sync
interval <1..1440>
[no] device-ha ap-mode backup sync
from master_address port port
device-ha ap-mode backup sync now
show device-ha ap-mode interfaces
show device-ha ap-mode next-sync-time
show device-ha ap-mode status
show device-ha ap-mode master sync
show device-ha ap-mode backup sync
show device-ha ap-mode backup sync
status
show device-ha ap-mode backup sync
summary
show device-ha ap-mode forwarding-port
interface_name
224
DESCRIPTION
Sets the management IP address for an interface.
Has device HA monitor the status of an interface's connection.
This is for a master ZyWALL. It specifies the password to require from
synchronizing backup ZyWALLs. Every router in the virtual router must use
the same password. The
no
(which means no backups can synchronize with this master).
password: Use 4-63 alphanumeric characters, underscores (_), dashes (-),
and characters.
#%^*={}:,.~
Sets the password the backup ZyWALL uses when synchronizing with the
master. The command sets the password setting to blank (which means
no
this backup ZyWALL cannot synchronize with the master).
password: Use 4-63 alphanumeric characters, underscores (_), dashes (-),
and characters.
#%^*={}:,.~
Turns on automatic synchronization according to the interval you specify in
device-ha ap-mode backup sync interval. The first synchronization
begins after the specified interval (not immediately).
When you use automatic synchronization, this sets how often (in minutes)
the ZyWALL synchronizes with the master.
Sets the address of the master ZyWALL with which this backup ZyWALL is
to synchronize.
master_address: The master ZyWALL's IP address or fully-qualified domain
name (FQDN).
port: The master ZyWALL's FTP port number.
Synchronize now.
Displays the device HA AP mode interface settings and status.
Displays the next time and date (in hh:mm yyyy-mm-dd format) the
ZyWALL will synchronize with the master.
Displays the ZyWALL's key device HA settings.
Displays the master ZyWALL's synchronization settings.
Displays the backup ZyWALL's synchronization settings.
Displays the backup ZyWALL's current synchronization status.
Displays the backup ZyWALL's synchronization settings.
If you apply Device HA on a bridge interface on a backup ZyWALL, you can
use this command to see which port in the bridge interface is chosen to
receive VRRP packets used to monitor if the master ZyWALL goes down.
interface_name: This is a bridge interface, For example, brx.
command sets the password setting to blank
ZyWALL (ZLD) CLI Reference Guide