Ike Sa Commands - ZyXEL Communications ZyWall Reference Manual

Table 70 Input Values for IPSec VPN Commands (continued)
LABEL
distinguished_name
sort_order
The following sections list the IPSec VPN commands.

17.2.1 IKE SA Commands

This table lists the commands for IKE SAs (VPN gateways).
Table 71 isakmp Commands: IKE SAs
COMMAND
show isakmp keepalive
show isakmp policy [policy_name]
isakmp keepalive <2..60>
[no] isakmp policy policy_name
activate
deactivate
authentication {pre-share | rsa-sig}
certificate certificate-name
[no] dpd
[no] fall-back
fall-back-check-interval <60..86400>
mode {main | aggressive}
transform-set isakmp-algo [isakmp_algo
[isakmp_algo]]
lifetime <180..3000000>
ZyWALL (ZLD) CLI Reference Guide
DESCRIPTION
A domain name. You can use up to 511 alphanumeric, characters, spaces, or .@=,_-
characters.
Sort the list of currently connected SAs by one of the following classifications.
algorithm
encapsulation
inbound
name
outbound
policy
timeout
uptime
DESCRIPTION
Displays the Dead Peer Detection period.
Shows the specified IKE SA or all IKE SAs.
Sets the Dead Peer Detection period.
Creates the specified IKE SA if necessary and enters sub-command
mode. The
Activates or deactivates the specified IKE SA.
Specifies whether to use a pre-shared key or a certificate for
authentication.
Sets the certificate that can be used for authentication.
Enables Dead Peer Detection (DPD). The
DPD.
Set this to have the ZyWALL reconnect to the primary address when
it becomes available again and stop using the secondary
connection, if the connection to the primary address goes down and
the ZyWALL changes to using the secondary connection.
Users will lose their VPN connection briefly while the ZyWALL
changes back to the primary connection. To use this, the peer
device at the secondary address cannot be set to use a nailed-up
VPN connection.
Sets how often (in seconds) the ZyWALL checks if the primary
address is available.
Sets the negotiating mode.
Sets the encryption and authentication algorithms for each IKE SA
proposal.
isakmp_algo: {des-md5 | des-sha | 3des-md5 | 3des-sha |
aes128-md5 | aes128-sha | aes192-md5 | aes192-sha | aes256-
md5 | aes256-sha | aes256-sha256 | aes256-sha512}
Sets the IKE SA life time to the specified value.
command deletes the specified IKE SA.
no
Chapter 17 IPSec VPN
command disables
no
143